Blog


Notice: Trying to access array offset on value of type bool in /home/chordmco/public_html/wp-content/themes/musiks/single.php on line 42

Joe’s Music Center

2017.02.14

545 Brooklyn Ave Brooklyn, NY 11225, USA

TEL:+1 718-774-0700

%
*可自行輸入百分比
*Input the run-in percentage
歡迎使用「Chord & Major 全頻煲機程式」
完整煲機流程約為60分鐘，請依以下指示開始進行煲機：

1.請將耳機與播放裝置連接。
2.請將播放裝置的音量設定至100%。
3.按下start鍵後開始進行煲機。
Welcome to Chord & Major Full Frequency Run-In Program
The whole progress is around 60 minutes, please go through the following steps:

1.Connect the earphone and the audio device.
2.Set the volume at 100% on device.
3.Press “START” to begin with the Run-in program.
*注意事項：
煲機過程中因頻率與音量的變化較大，不建議直接聆聽。
*Note:
Not recommend to listen to the music through earphone during running this program due to the high volume setting and frequency changes.

第一階段：線性跑動

Step 1: Linear-Drive

頻率運作範圍：0Hz~45kHz
時間：約20min
本階段針對耳機進行基礎熱身，讓耳機循序漸進地全頻運作，讓彈性恢復

Frequency: 0Hz ~ 45kHz
Time: 20 mins

This step is to do a basic warm-up for the earphone and let it play through all frequencies gradually to perform a better drive flexibility.

第二階段：瞬態反應

Step 2: Dynamic Response

頻率運作範圍：0Hz~45kHz
時間：約10min
密集的瞬間動態動作，進行更高壓的極端熱機，讓性能運作達最佳化。

Frequency: 0Hz~45kHz
Time: 10 mins

Through the frequent dynamic responses to highly congress the burn-in progress for maximising the functions.

第三階段：全頻緩機

Step 3: Full Frequency Ease-up

頻率運作範圍：0Hz~45kHz
時間：約30min
開始進行疏緩，讓耳機緩機，保留其延展性，讓驅動狀態穩定。

Frequency: 0Hz~45kHz
Time: 30 mins

Begin to ease-up the earphone for remaining the ductility and stabilise the driver.

START
PLAY
STOP
語言：繁中 / 日本語 / English