Blog


Major 9’13 Classical Tonal Earphone Review by Classical Music Headphones (English)

classical music headphones

The Materials

The Classical Tonal earphones are constructed out of unique materials that give it a unique look and sound.

The earphones themselves are constructed out of rosewood to bring out more warmthin the sound. The earbuds are soft and fit into my ears with no problem. The earphones come with a half dozen different buds for different ear sizes, but the default size fit my ears just fine (I appear have generic white male ears).

The backs of the earphones are gold-plated, and feel heavier in your hand than your average buds. They have a neat little cable loop that protects the cable at common stress points. The rubberized material is a cut above conventional plastic cords, which tend to easily fray and tangle. Overall the presentation is classy. The rosewood/gold combination made the earphones look like something a CEO uses at his desk.

I liked the look and the feel of the earphones. The only downside? This is just my observation, but when I saw myself wearing the earphones, it kind of looked like I was wearing earrings. There’s nothing wrong with that, it’s just I’m not a bling-wearer, so it felt unusual for me.

11

Sound Quality

「What really surprised me about the earphones is how well they handled the low range (i.e. bass). I sampled lots of classical music, from symphonies to movie soundtracks to solo violin, and it handled them all pretty well. While they definitely have great warmth, they don’t have a very strong soundstage. All the distinct sounds come from the same place, as if listening to an orchestra from the middle of an amphitheatre.」

Conclusion

These earphones are a great example of specialization at work: if you make earphones that work amazingly well at one genre of music, it may come at the cost of other genres. A good example of this is the Beats headphones: the emphasis on bass (the low-end) means that they offer below par sound quality in other genres. And frankly, it’s good to see audio manufacturers catering to listeners of these other genres.

2

Original source: http://classicalmusicheadphones.audio/chord-major-classical-earphones-review/

%
*可自行輸入百分比
*Input the run-in percentage
歡迎使用「Chord & Major 全頻煲機程式」
完整煲機流程約為60分鐘,請依以下指示開始進行煲機:

1.請將耳機與播放裝置連接。
2.請將播放裝置的音量設定至100%。
3.按下start鍵後開始進行煲機。
Welcome to Chord & Major Full Frequency Run-In Program
The whole progress is around 60 minutes, please go through the following steps:

1.Connect the earphone and the audio device.
2.Set the volume at 100% on device.
3.Press “START” to begin with the Run-in program.
*注意事項:
煲機過程中因頻率與音量的變化較大,不建議直接聆聽。
*Note:
Not recommend to listen to the music through earphone during running this program due to the high volume setting and frequency changes.

第一階段:線性跑動

Step 1: Linear-Drive

頻率運作範圍:0Hz~45kHz
時間:約20min
本階段針對耳機進行基礎熱身,讓耳機循序漸進地全頻運作,讓彈性恢復

Frequency: 0Hz ~ 45kHz
Time: 20 mins

This step is to do a basic warm-up for the earphone and let it play through all frequencies gradually to perform a better drive flexibility.

第二階段:瞬態反應

Step 2: Dynamic Response

頻率運作範圍:0Hz~45kHz
時間:約10min
密集的瞬間動態動作,進行更高壓的極端熱機,讓性能運作達最佳化。

Frequency: 0Hz~45kHz
Time: 10 mins

Through the frequent dynamic responses to highly congress the burn-in progress for maximising the functions.

第三階段:全頻緩機

Step 3: Full Frequency Ease-up

頻率運作範圍:0Hz~45kHz
時間:約30min
開始進行疏緩,讓耳機緩機,保留其延展性,讓驅動狀態穩定。

Frequency: 0Hz~45kHz
Time: 30 mins

Begin to ease-up the earphone for remaining the ductility and stabilise the driver.

START
PLAY
STOP
語言:繁中 / 日本語 / English